Módulo transceptor SFP BlueOptics H-LX-SFP/R-BO 1250 Mbit/s

The BlueOptics H-LX-SFP/R-BO 1250 Mbit/s is an SFP transceiver module designed for optical fiber connections. It supports a maximum data transfer rate of 1250 Mbit/s and uses an SFP interface in a compact silver form factor. The module implements 1000BASE-LX optical signaling with separate transmitter and receiver functions around 1310 nm and connects via LC duplex. With a stated mean time between failures (MTBF) of 3,000,000 hours and compliance with RoHS, FCC and CE standards, the transceiver is intended for reliable integration in common network equipment that supports MSA-compatible SFP modules.

Advantages

The module offers a small SFP form factor compatible with MSA-compliant sockets and devices. Its 1000BASE-LX operation and LC duplex connection enable optical signal transmission over fiber using 1310 nm wavelengths. The declared MTBF of 3,000,000 hours and regulatory compliance (RoHS, FCC, CE) support long-term, standards-compliant use in network environments. The silver housing and lightweight construction contribute to straightforward handling and installation in tight rack or chassis environments.

Suitable for

Key specifications

How to use

Install the transceiver into an empty MSA-compatible SFP slot on the network device until it clicks into place, then connect LC duplex fiber patch cables to the transmit and receive ports. Ensure correct polarity of the fibers and that the connected device is configured for 1000BASE-LX operation. After physical installation, verify link status and data rate through the host device management interface and perform any required software or firmware configuration to enable the port.

Recommendations

Use single-mode or multimode fiber as appropriate for your distance and link budget; confirm fiber type and connector polarity before powering network equipment. Keep the transceiver dust caps on when not connected and avoid excessive force when inserting or removing the module. Verify compatibility with the host device's SFP support list and test the link after installation.