Módulo transceptor SFP BlueOptics ISFP-100-MM-BO cobre 155 Mbit/s

The BlueOptics ISFP-100-MM-BO Copper 155 Mbit/s is an SFP transceiver module designed for reliable network connectivity. It supports a maximum data transfer rate of 155 Mbit/s, has an SFP interface and is supplied in a compact, lightweight housing of approximately 20 g with a grey finish. The module is intended for use in systems that accept standard SFP transceivers and follows MSA-compatible mechanical and electrical characteristics.

Advantages

This SFP transceiver provides a compact, industry-standard form factor and straightforward plug-and-play integration into SFP-capable network equipment. Its lightweight construction and compliance with common SFP interface conventions simplify installation and replacement. The module is built to support stable data transfer at the specified rate and is suitable for environments where a standardized optical or copper SFP interface is required.

Suitable for

Key specifications

How to use

Insert the BlueOptics ISFP-100-MM-BO into an empty SFP port on compatible network hardware while the device is powered down or following the host manufacturer’s hot-swap guidance. Ensure the module is fully seated in the SFP slot and secure any locking mechanism if present. Connect the appropriate cable or fiber patch cord according to the port type and wavelength requirements. After installation, verify link status and negotiate the correct link speed on the host device according to its configuration interface.

Recommendations

Use this SFP transceiver in equipment that supports standard SFP modules and confirm compatibility with the host device documentation. For optimal performance, pair the module with suitable patch cords and maintain clean connector end-faces. Store and operate the module within the environmental ranges specified by your host system to preserve lifetime and reliability.