Módulo transceptor SFP+ BlueOptics J9150-69101 10000 Mbit/s 850 nm

The BlueOptics J9150-69101 SFP+ transceiver module is a compact fiber optic interface designed for short-range high-speed links. Supporting a maximum data rate of 10,000 Mbit/s and operating at an 850 nm wavelength, this module is intended for use in data centers, server-to-switch connections and enterprise network uplinks that require reliable 10 GbE connectivity over multimode fiber. The SFP+ form factor provides hot-pluggable installation and broad compatibility with networking equipment that accepts SFP+ optics.

Advantages

This transceiver offers 10 Gbit/s performance with an 850 nm VCSEL-based optical interface suitable for short-range multimode fiber links. Its SFP+ compact form factor supports hot-swap installation and reduces rack space compared with larger optics. The module is designed for interoperability with a variety of switches, routers and network cards that accept SFP+ optics and provides a predictable link behavior for standard 10 Gigabit Ethernet applications.

Suitable for

• 10 Gigabit Ethernet links over multimode fiber in data centers
• Server-to-switch and switch-to-switch short-reach connections
• Enterprise access uplinks and aggregation points requiring 10 Gbit/s

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10,000 Mbit/s
• Operating wavelength: 850 nm
• Optical medium: multimode fiber (short reach)
• Form factor: hot-pluggable SFP+ transceiver

How to use

Install the BlueOptics J9150-69101 module into an SFP+ port on compatible network equipment until it clicks into place. Connect the multimode fiber patch cable to the transceiver's optical interface, ensuring correct cable type and connector orientation. After physical installation, verify link status and speed on connected devices and configure network settings as required. To remove the module, power down the port if required by the equipment manual or follow hot-swap procedures, then gently release and pull the module out of the cage.

Recommendations

Use OM3/OM4 multimode fiber for reliable short-range 10 Gbit/s links, keep optical connectors clean and use dust caps when the transceiver is not connected. Verify compatibility with the specific switch or host vendor and ensure firmware or driver settings allow third-party SFP+ modules if necessary.