Módulo transceptor SFP+ BlueOptics J9152AS-BO 10000 Mbit/s 1310 nm

The BlueOptics J9152AS-BO SFP+ transceiver module is a fiber optic network component designed for 10 Gbit/s links over multimode fiber using a 1310 nm wavelength. The module follows SFP+ form-factor standards and provides a compact, pluggable solution for devices that support SFP+ optics. Constructed in a silver housing and weighing approximately 0.02 kg, it is intended for use in network equipment where reliable short- to medium-range optical connectivity is required. The product complies with RoHS, CE and FCC directives and is engineered with a high mean time between failures (MTBF) of 1,000,000 hours to support continuous operation.

Advantages

The transceiver delivers a maximum data transfer rate of 10000 Mbit/s and uses a 1310 nm transmitter and receiver suited for multimode fiber links. Its SFP+ interface ensures physical and electrical compatibility with standard SFP+-capable ports. The compact module supports LC duplex connections and is built to meet common industry standards, enabling straightforward integration into switches, routers and storage devices that accept SFP+ optics. High MTBF and compliance with regulatory standards contribute to dependable long-term operation.

Suitable for

• 10 Gbit/s Ethernet links over multimode fiber within data centers and server rooms
• Interconnects between switches, routers and storage systems that accept SFP+ optics
• Upgrades or replacements for SFP+ ports requiring 1310 nm multimode transceivers

Key specifications

• Form factor: SFP+
• Maximum data transfer rate: 10000 Mbit/s
• Optical wavelength: 1310 nm
• Connector type: LC duplex (multimode fiber)
• Typical operating lifetime indicator: MTBF 1,000,000 hours
• Product colour: Silver
• Weight: approx. 0.02 kg
• Regulatory compliance: RoHS, CE, FCC

How to use

Insert the BlueOptics J9152AS-BO SFP+ module into a compatible SFP+ port on your network device until it locks into place. Connect LC duplex multimode fiber patch cords to the module, ensuring transmit and receive fibers are correctly aligned. Configure the host device as required for a 10 Gbit/s link and verify link status through the device management interface. If the host supports digital diagnostics (DDM/DOM), enable and monitor diagnostics to check optical power, temperature and supply parameters where supported by the equipment.

Recommendations

Use high-quality multimode LC duplex patch cords and avoid excessive bending of fiber to maintain signal integrity. Confirm that the network equipment firmware or software supports third-party SFP+ modules and, if necessary, test the module in a non-critical segment before full deployment. Follow standard electrostatic discharge (ESD) precautions when handling the transceiver.