Módulo transceptor SFP BlueOptics MG-1000PU1I-BO 1250 Mbit/s plata

The BlueOptics MG-1000PU1I-BO 1250 Mbit/s Silver is an SFP transceiver module for single-fibre optical links. Designed according to MSA standards, it provides 1250 Mbit/s data throughput with LC simplex connectivity and supports long-distance transmission up to 40,000 m. The module implements separate transmit (1310 nm) and receive (1550 nm) wavelengths on a single fibre (1000BASE-BX-U) and includes digital diagnostics monitoring (DDM/DOM) for real-time reporting of operating parameters. The compact 20 g silver module is suitable for installation in switches, routers, storage systems and other networking hardware that accept SFP form-factor transceivers.

Advantages

The MG-1000PU1I-BO follows established MSA specifications to ensure mechanical and electrical compatibility with common networking equipment. Its LC simplex connector and single-fibre duplexing (BX-U) design enable long-reach links without additional fibres. Integrated digital diagnostics allow monitoring of temperature, supply voltage, laser bias current, transmit power and receive power for easier maintenance and fault finding. Components are selected for reliability, contributing to a long MTBF and sustained availability in production networks.

Suitable for

Key specifications

How to use

Insert the SFP transceiver into a compatible SFP port on your switch, router or other network device while the device is powered according to the vendor's service instructions. Connect an LC simplex patch cable or pigtail to the module, ensuring correct alignment for the single-fibre BX-U link (transmit and receive wavelengths are on different directions). Enable or verify link settings on the host device and confirm DDM availability in the management interface if remote diagnostics are required. Follow standard electrostatic discharge (ESD) precautions and keep dust caps on the optical interface until ready for connection.

Recommendations

Use quality single-mode LC simplex patch cables matched to the intended link length and connector polish. Verify that the host device firmware supports 1000BASE-BX-U and DDM/DOM to access diagnostic data. For longest lifetime and stable operation, maintain clean fiber endfaces and operate the module within the vendor-specified temperature and power ranges.