Módulo transceptor SFP+ BlueOptics MP-S311X2-NCL20-BO 10000 Mbit/s

The BlueOptics MP-S311X2-NCL20-BO is an SFP+ transceiver module designed for high-speed fiber optic data transfer. It supports a maximum data rate of 10000 Mbit/s and implements the compact SFP+ form factor with an LC duplex optical interface. The module is lightweight (approx. 20 g) and intended for single-mode fiber links, enabling optical transmission over extended distances where supported by the link design and hardware.

Advantages

This SFP+ transceiver offers a standardized SFP+ interface for easy hot-pluggable installation in compatible network equipment. Its support for 10 Gbit/s data rates and LC duplex optical connection enables simultaneous transmit and receive channels on separate fibers. The module is built to industry MSA form-factor standards and is available in a silver housing that facilitates compact installation and compatibility with a wide range of switches, routers and storage interfaces.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP+ transceiver into a compatible SFP+ port on your switch, router or storage device while the device is powered according to your equipment vendor guidelines for hot-plug operations. Connect the LC duplex single-mode fiber patch cord to the module, observing correct TX/RX orientation. Verify link status and speed through the host device management interface. If your hardware supports digital diagnostics monitoring (DDM/DOM), enable or query that function to monitor parameters such as optical power and module temperature if available.

Recommendations

Confirm compatibility with the host device before deployment and use single-mode LC duplex fiber patch cords rated for 10G operation. Follow manufacturer guidelines for ESD protection during handling and ensure that transceiver firmware or vendor compatibility settings are configured if required.