Módulo transceptor SFP+ BlueOptics PAN-SFP-PLUS-ER-BO 40000 nm aluminio

The BlueOptics PAN-SFP-PLUS-ER-BO is a 10G SFP+ fiber optic transceiver module designed for single‑mode links. Constructed with an aluminium housing and weighing approximately 20 g, the module provides a standardized SFP+ interface and LC duplex connectivity for high-speed optical transmission. It supports long‑reach applications and is intended for integration into network devices that accept SFP+ form‑factor transceivers.

Advantages

The aluminium housing offers mechanical robustness and helps dissipate heat during continuous operation. The SFP+ interface ensures broad compatibility with equipment that follows MSA standards. Compact dimensions and low weight simplify handling and installation in dense rack environments while maintaining a professional optical connection via LC duplex.

Suitable for

• 10 Gigabit Ethernet uplinks and links over single‑mode fiber
• Long‑reach network connections requiring ER‑class transceivers
• Installation in switches, routers, firewalls and storage systems that accept SFP+ modules
• Replacement or spare module inventory for network maintenance

Key specifications

• Interface type: SFP+
• Connector: LC duplex
• Optical class: long‑reach (ER) for single‑mode fiber
• Wavelength: 40000 nm (as stated by manufacturer data)
• Housing material: aluminium
• Weight: 0.02 kg

How to use

Power down or follow hot‑swap procedures recommended by your hardware vendor before inserting or removing the transceiver to avoid damage. Align the LC duplex connector and insert the module into an SFP+ slot until it latches. Connect appropriate single‑mode fiber patch cords with matching LC duplex connectors and verify link status in the host device. Monitor optical parameters and link state via the host management interface if supported.

Recommendations

Use clean, undamaged LC connectors and single‑mode fiber patch cords rated for long‑reach transmission. Confirm that the host device supports the SFP+ ER class transceiver and that any firmware or software lockout for third‑party modules is addressed prior to deployment. Store unused modules in anti‑static packaging and protect optical interfaces with dust caps when not connected.