Módulo transceptor SFP BlueOptics SFP-10G-LR-QN 10000 Mbit/s 1310 nm

The BlueOptics SFP-10G-LR-QN is an SFP+ fiber optic transceiver module engineered for high-speed network links up to 10 Gbit/s. Operating at a wavelength of 1310 nm, this module is intended for long-reach single-mode fiber connections and fits standard SFP+ slots for flexible deployment. The compact, lightweight silver module weighs approximately 20 g and is suitable for use in switches, routers and other network equipment that accept SFP+ optics.

Advantages

This SFP transceiver supports a maximum data transfer rate of 10000 Mbit/s and uses a 1310 nm optical window optimized for extended-range transmission over single-mode fiber. Its SFP+ interface provides backward compatibility with equipment that supports SFP+ form factors, allowing straightforward hot-pluggable installation. The module’s small size and low weight simplify inventory and physical handling while maintaining industry-standard optical performance.

Suitable for

• Long-distance single-mode fiber links in campus or metropolitan networks
• 10 Gbit/s uplinks between switches and routers
• Data center server-to-switch connections requiring SFP+ optics
• Telecommunications and carrier aggregation where 1310 nm wavelength is specified

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Operating wavelength: 1310 nm
• Form factor: SFP+ hot-pluggable transceiver
• Typical application: long-reach single-mode fiber communication
• Weight: 0.02 kg (approx. 20 g)
• Color: silver

How to use

Install the BlueOptics SFP-10G-LR-QN by inserting the module into a compatible SFP+ port until it clicks into place. Connect the appropriate single-mode fiber cable with matching LC connectors to the module’s optical interface, ensuring correct transmit/receive orientation. Verify link status through your networking equipment’s management interface and configure link speed or auto-negotiation settings as required. For safe removal, disable the port if supported and gently withdraw the module using the release latch.

Recommendations

Use single-mode fiber cabling rated for long-reach 1310 nm transmission, maintain clean fiber connectors to prevent signal loss, and follow manufacturer guidelines for ESD protection when handling the transceiver. Validate compatibility with your switch or router vendor to ensure full operational support.