Módulo transceptor SFP BlueOptics SFP-10G-USR-DE-DE-BO 10000 Mbit/s 850 nm

The BlueOptics SFP-10G-USR-DE-DE-BO is an SFP+ fiber-optic transceiver module engineered for 10 Gbit/s data links over multimode fiber. It operates at an 850 nm wavelength and uses an LC duplex connector following MSA standards. The module is housed in metal, weighs approximately 3 g and is powered by a 3.3 V input supply. It supports typical 10GBASE-SR applications and is intended for installation in compatible network equipment that accepts SFP+ optical modules.

Advantages

This SFP+ transceiver offers a compact metal housing for mechanical stability and heat dissipation, and it implements the widely used 850 nm short-range optical interface suitable for multimode fiber. The module conforms to SFP+ form-factor and LC duplex connection conventions, enabling straightforward installation and interoperability with equipment that follows MSA specifications. Its low weight and standard 3.3 V supply make it compatible with most SFP+ slots.

Suitable for

• 10G Ethernet links over multimode fiber (short-reach)
• Connections between switches, routers, and storage systems
• Data center uplinks and aggregation ports
• High-speed links within campus or enterprise wiring closets

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10,000 Mbit/s (10 Gbit/s)
• Wavelength: 850 nm (VCSEL)
• Connector: LC duplex
• Suitable fiber: Multimode fiber (MMF)
• Typical reach (multimode): short-range, up to ~300 m depending on fiber type and link conditions
• Operating voltage: 3.3 V
• Housing: metal
• Weight: ~3 g

How to use

Install the BlueOptics SFP-10G-USR-DE-DE-BO into an available SFP+ slot on a compatible switch, router or storage interface. Use LC duplex multimode fiber patch cords to connect to the remote transceiver or patch panel, observing correct transmit/receive orientation. After seating the module, verify link status in the host device management interface and confirm the negotiated speed and diagnostics if supported. Follow standard electrostatic discharge (ESD) precautions when handling the transceiver and keep protective dust caps on unused connectors.

Recommendations

For optimal performance, use high-quality OM3/OM4 multimode fiber and LC duplex patch cords, ensure connectors and adapters are clean, and verify that the host hardware supports SFP+ 10GBASE-SR modules and any Digital Diagnostics Monitoring (DDM/DOM) functions you require.