Módulo transceptor SFP BlueOptics SFP-1GLSXLC 1250 Mbit/s 1310 nm

The BlueOptics SFP-1GLSXLC 1250 Mbit/s 1310 nm is a small form-factor pluggable (SFP) fiber optic transceiver module designed for single-mode links operating at a 1310 nm wavelength. It supports a maximum data transfer rate of 1250 Mbit/s and fits standard SFP interfaces, providing a compact solution for adding optical connectivity to switches, routers and media converters. The module is intended for deployments where stable, point-to-point fiber links are required over distances typical for 1310 nm single-mode transceivers.

Advantages

The module offers a standardized SFP form factor for hot-pluggable installation and easy replacement without powering down equipment. Its operation at 1310 nm and support for 1250 Mbit/s enable compatibility with common Gigabit optical networks and legacy equipment that require this wavelength. The compact design reduces footprint in networking racks while delivering reliable optical performance for consistent data transmission.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP-1GLSXLC into an available SFP slot on a compatible switch, router or media converter until it clicks into place. Connect single-mode fiber cables with appropriate LC connectors to the module’s optical ports. Ensure both ends of the fiber link use matching wavelength and transceiver types (1310 nm single-mode) and verify link status via the host device interface. If required, configure network settings on the host equipment and monitor optical signal indicators to confirm proper operation.

Recommendations

Use this transceiver with single-mode fiber and LC connectors, keep dust caps on when the fiber ports are not connected, and verify compatibility with the host device’s SFP interface. Avoid exposing the module to extreme temperatures or mechanical shock during installation. For optimal performance, follow the fiber vendor’s recommendations for attenuation and connector cleanliness.