Módulo transceptor SFP BlueOptics SFP-2000-SM13-10-BO 10000 Mbit/s SFP+

The BlueOptics SFP-2000-SM13-10-BO is a fiber optic SFP+ transceiver module designed for 10 Gbit/s connections over single-mode fiber. The module uses an LC duplex connector, operates with 1310 nm optics for long-reach applications and offers a maximum transfer distance of up to 10,000 meters while weighing approximately 20 g. Its compact, silver housing conforms to SFP+ form factor standards and is intended for use in devices with SFP+ ports to provide reliable high-speed network links.

Advantages

This BlueOptics SFP+ transceiver delivers 10 Gbit/s throughput over single-mode fiber with an LC connector and a rated reach of up to 10 km, allowing stable long-distance optical links. The lightweight, standardized form factor ensures compatibility with a broad range of SFP+ enabled switches, routers and storage equipment. The module's silver metal housing supports mechanical durability while keeping thermal characteristics appropriate for typical networking environments.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP-2000-SM13-10-BO into an available SFP+ port until it latches; ensure the host device is powered according to the vendor guidelines. Connect an LC duplex single-mode fiber patch cable, observing correct transmit/receive orientation. After physical installation, verify link status and speed in the host device interface; if necessary, check firmware or driver compatibility on the switch or router. For optimal performance, use single-mode fiber infrastructure rated for long-reach 10G connections.

Recommendations

Confirm that the target device supports SFP+ modules and the 10GBASE-LR or equivalent protocol. Use certified single-mode LC patch cords and proper fiber management to maintain low attenuation. If digital diagnostic monitoring is required, ensure the host hardware supports DDM/DOM to access real-time diagnostic parameters. Handle the transceiver with ESD precautions and replace protective dust caps when the module is not connected to protect the optical interfaces.