Módulo transceptor SFP BlueOptics SFP-BXD43-20KM-NA-BO 1250 Mbit/s

The BlueOptics SFP-BXD43-20KM-NA-BO is a compact SFP transceiver module engineered for fiber optic network links with a maximum data transfer rate of 1250 Mbit/s. Housed in metal and weighing approximately 20 g, this module is intended for deployment in networking equipment that accepts standard SFP form factors. It supports single-port fiber connections and is suitable for establishing reliable links over extended distances where an SFP interface is required.

Advantages

The metal housing provides mechanical durability and helps with heat dissipation during continuous operation. With a standard SFP interface and a maximum transfer speed of 1250 Mbit/s, the module integrates with a wide range of switches, routers and media converters that support SFP transceivers. Its light weight and compact SFP form factor make installation and replacement straightforward while minimizing space usage in network racks or chassis.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP-BXD43-20KM-NA-BO into an available SFP slot on compatible networking equipment while the device is powered down or following the manufacturer's hot-swap guidance. Connect the appropriate fiber optic cable to the transceiver's receptacle, ensuring correct polarity and connector type. Configure the host device interface as required by the network (link speed, duplex and any optical settings) and verify link status through the device management interface or LED indicators. Follow standard safety procedures when handling fiber optic connectors to avoid damage or contamination.

Recommendations

Verify compatibility with the switch or router vendor and confirm the required fiber type and connector before installation. Keep fiber endfaces clean and use dust caps when the transceiver is not connected. For reliable long-distance operation, use appropriate fiber cabling and test the link with diagnostic tools after installation.