Módulo transceptor SFP BlueOptics SFP-BXU35-40KM-BR-BO 1250 Mbit/s

The BlueOptics SFP-BXU35-40KM-BR-BO is a single‑port SFP transceiver module designed for fiber optic links with a maximum data transfer rate of 1250 Mbit/s. Housed in a metal enclosure with a silver finish, the module is compact and lightweight (approximately 20 g) and is intended for use in network equipment that accepts SFP form‑factor optics. A high mean time between failures (MTBF) of 1,000,000 hours indicates long operational lifetime under normal conditions.

Advantages

This transceiver offers a standard SFP interface compatible with a wide range of switches and routers that support SFP modules. The metal housing provides mechanical protection and contributes to thermal stability during operation. With a compact size and low weight, the module is easy to install and replace in dense networking environments. The specified MTBF supports predictable maintenance planning and helps reduce downtime risk.

Suitable for

Key specifications

How to use

Ensure the host device supports SFP transceivers and the required wavelength or link type before installation. Power down the port or follow hot‑swap procedures recommended by the equipment vendor, insert the transceiver into an empty SFP slot until it seats firmly, and connect the appropriate single‑mode fiber cable. Verify link status and configure port settings on the switch or router as needed to match the 1250 Mbit/s operation and any duplex or protocol requirements.

Recommendations

Store and handle the module in a clean, dry environment and use dust caps when the transceiver or fiber connectors are not in use. Match fiber type and connector polish to the network design and verify compatibility with the host equipment's supported SFP specifications before deployment.