Módulo transceptor SFP BlueOptics SPL-35-GB-BD-IDFM-BO 1250 Mbit/s

The BlueOptics SPL-35-GB-BD-IDFM-BO is an SFP fiber optic transceiver module designed for single-port networking equipment. It supports a maximum data transfer rate of 1250 Mbit/s and operates from a 3.3 V input, housed in a compact metal casing with a silver finish and a lightweight construction of approximately 2 g. The module follows standard SFP form-factor dimensions and provides a physical interface for fiber-optic links in switches, routers and media converters.

Advantages

The metal housing offers mechanical durability and thermal stability while the small SFP form factor enables flexible deployment in dense rack-mounted equipment. With a 1250 Mbit/s transfer capability and low weight, the module is suitable for high-speed fiber connections where space and power consumption are constrained. The standardized interface ensures compatibility with a broad range of network devices that accept SFP transceivers.

Suitable for

• Single-port fiber links between switches and routers
• Media converters and fiber uplinks in enterprise networks
• Telecom and data center fiber patch connections requiring SFP modules
• Replacement or upgrade of existing SFP transceivers

Key specifications

• Interface type: SFP small form-factor pluggable
• Maximum data transfer rate: 1250 Mbit/s
• Operating voltage: 3.3 V input
• Housing material: metal
• Colour: silver
• Weight: approximately 0.002 kg (2 g)

How to use

Insert the BlueOptics SFP transceiver into a compatible SFP port on a switch, router or media converter until it latches. Connect the appropriate fiber-optic cable to the module’s optical interface, observing the correct transmitter/receiver alignment. Power the host device with its standard supply; the transceiver draws from the host 3.3 V rail. Monitor link LEDs or device diagnostics to confirm link establishment and proper data transmission at up to 1250 Mbit/s.

Recommendations

Handle the module by its housing and avoid touching the optical connector faces. Keep dust caps on unused ports and clean fiber connectors before insertion. Verify compatibility with the host device’s SFP port and firmware to ensure proper operation.