Módulo transceptor SFP BlueOptics SPL-53-GB-BX-IDFM-BO 1250 Mbit/s

The BlueOptics SPL-53-GB-BX-IDFM-BO 1250 Mbit/s is an SFP fiber optic transceiver module designed for serial optical communication links. It supports a maximum data transfer rate of 1250 Mbit/s, comes in a metal housing with a silver finish and is powered by a standard 3.3 V input. With a compact SFP form factor and a lightweight build of approximately 2 g, this module is compatible with network equipment that accepts SFP pluggable transceivers for single-fiber or simplex fiber applications.

Advantages

The metal housing provides mechanical robustness and electromagnetic shielding while maintaining a low weight. The 3.3 V input voltage conforms to common SFP electrical specifications, enabling straightforward integration into compatible switches, routers or media converters. Its compact SFP interface saves space in dense 1G networking environments and the silver finish corresponds to standard transceiver appearance for easy identification.

Suitable for

• Fiber uplinks between switches and routers in LAN environments
• Media converters and SFP-capable network devices
• Point-to-point single-fiber links in enterprise networks
• Replacing or expanding existing SFP transceiver ports

Key specifications

• Form factor: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Operating voltage: 3.3 V input
• Housing material and colour: metal housing, silver
• Weight: approximately 0.002 kg (2 g)

How to use

Ensure the target device supports SFP transceivers and the required optical link type. With the network equipment powered down or following the vendor's hot-swap guidance, insert the BlueOptics SFP module into an available SFP slot until it seats securely. Connect the appropriate fiber cable to the transceiver port, observing correct connector type and polarity for single-fiber links. Power up the equipment or verify the device recognizes the module; monitor link LEDs or device status to confirm an active connection. Follow network device configuration steps to enable and test the interface.

Lietošanas ieteikumi

The module should be handled by the edges to avoid touching optical interfaces; protect the fiber connector with dust caps when not in use and verify compatibility with the host device's supported transceiver types and wavelengths before installation.