Módulo transceptor SFP28 BlueOptics SFP28-25G-ERL-30-BC-BO 25000 Mbit/s

The BlueOptics SFP28-25G-ERL-30-BC-BO is a fiber optic transceiver module engineered for high-speed 25 Gbps connections using an SFP28 interface. Designed for use in modern network infrastructures, this module provides a compact form factor compatible with compatible SFP28 ports and supports reliable optical transmission for longer-reach links. It is intended for deployment in data centre and enterprise environments where stable, high-bandwidth connectivity is required.

Advantages

This transceiver supports a maximum data transfer rate of 25000 Mbit/s over fiber and is built to integrate with SFP28-capable switches and routers. Its small-size pluggable design allows hot-swap installation without powering down equipment. The module is suitable for long-reach optical links, offering consistent performance for demanding network workloads while maintaining industry-standard compatibility for broad interoperability.

Suitable for

• 25 Gbps uplinks between switches and aggregation devices
• Server to switch connections in data centres
• Enterprise backbone and campus network links
• Long-reach fiber connections where SFP28 form factor is required

Key specifications

• Interface type: SFP28 small form-factor pluggable
• Maximum data transfer rate: 25000 Mbit/s (25 Gbps)
• Fiber optic transmission suitable for extended reach links
• Hot-pluggable compact design for in-service replacement

How to use

Insert the SFP28 transceiver into an available SFP28 port on a compatible switch, router or network interface card until it clicks into place. Connect the appropriate single-mode or multimode fiber cable, depending on the installed optics and network design, and ensure proper connector type and polarity. After physical installation, verify link status via the network device management interface and configure port settings (speed, duplex, and any required optical parameters) according to your network policies.

Recommendations

Confirm compatibility with the host device’s SFP28 port and optical system before installation. Use recommended fiber type, patch cables and connectors for the intended reach. Handle the transceiver by the housing and avoid touching the optical interfaces; keep protective caps in place until connection. Monitor link parameters and perform optical power tests if troubleshooting link issues.