Módulo transceptor SFP28 BlueOptics X65404-BO 25000 Mbit/s

The BlueOptics X65404-BO SFP28 transceiver module is a hot-pluggable fiber-optic interface designed for 25G high-speed network links. Built in a metal housing and finished in silver, this SFP28 module supports a maximum data transfer rate of 25,000 Mbit/s and is intended for multi-mode fiber connections using an LC duplex connector. The module is compact and lightweight (approximately 20 g) and is specified with a high mean time between failures (MTBF) to support long-term deployment in network equipment that accepts SFP28 form-factor transceivers.

Advantages

The BlueOptics X65404-BO provides a standardized SFP28 interface for 25G applications, offering compatibility with equipment that follows SFP28 MSA specifications. Its metal housing contributes to mechanical robustness and heat dissipation, while a documented MTBF supports predictable reliability planning. The compact, hot-pluggable design enables easy installation and replacement in switches, routers, storage systems, and other network hardware that accept SFP28 transceivers.

Suitable for

Key specifications

How to use

Install the SFP28 module into a compatible SFP28 port while the host device is powered down or following the device vendor's hot-swap instructions. Connect an LC duplex multi-mode fiber patch cable to the module ensuring correct transmit/receive orientation. Verify link status and speed on the host device and confirm that the device firmware supports SFP28 modules and the appropriate optical specification. If present, enable and monitor digital diagnostics features through the host system per vendor documentation.

Recommendations

Use high-quality OM3/OM4 multi-mode fiber patch cables and proper LC duplex connectors for optimal short-reach performance. Ensure the host equipment supports SFP28 modules and the required 25G data rate. Handle the transceiver by its housing, avoid touching the optical interfaces, and keep protective caps on when not in use to prevent contamination.