Módulo transceptor XFP BlueOptics XFP10GLR-192SR-L 10000 Mbit/s 1310 nm

The BlueOptics XFP10GLR-192SR-L is an XFP fiber optic transceiver module designed for 10 Gbit/s data links. Operating at a 1310 nm wavelength, this module supports high-speed serial data transmission and is intended for use in compatible networking equipment that accepts XFP form-factor modules. The unit follows XFP standards to ensure interoperability with switches, routers and optical line cards that support XFP modules.

Advantages

The module delivers a 10000 Mbit/s maximum data transfer rate over single-mode fiber at 1310 nm wavelength, providing a balance between reach and dispersion tolerance for metropolitan and enterprise networks. Its standardized XFP interface simplifies installation and replacement in systems that accept hot-pluggable XFP transceivers. Compliance with common XFP electrical and optical specifications helps maintain reliable link performance and predictable integration into existing optical networks.

Suitable for

• 10 Gbit/s uplinks between switches and routers using XFP ports
• Long-reach or metro fiber links over single-mode fiber at 1310 nm
• Optical line cards and chassis requiring standardized XFP transceivers
• Network equipment upgrades where hot-swappable XFP modules are supported

Key specifications

• Form factor: XFP transceiver module
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Optical wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Hot-pluggable: yes (XFP standard)

How to use

Install the BlueOptics XFP10GLR-192SR-L into an empty XFP slot on a compatible switch, router or optical line card while the host device is powered on or following the equipment manufacturer’s guidance for hot-swap procedures. Connect an appropriate single-mode fiber patch cable to the transceiver’s optical port, ensuring correct transmit/receive alignment. Configure the network device’s interface settings to match 10 Gbit/s operation if manual configuration is required. Verify link status and diagnostics through the host device management interface.

Recommendations

Use single-mode fiber rated for 1310 nm transmission, maintain clean optical connectors and follow ESD precautions during installation. Confirm compatibility with the host device’s XFP specifications and supported feature set before deployment to ensure reliable operation.