Nivelador Rittal 8660.121 Acero inoxidable 200 mm de altura

Leveler for base/plinth system VX, sheet steel, new version. Designed for retrospective levelling on uneven floors at the installation site up to a maximum of 15 mm, the component is fitted through the base/plinth corner piece to provide stable height adjustment for rack and cabinet installations. This stainless steel leveler has a nominal height of 200 mm and is supplied in a pack of four for use with VX base systems.

Advantages

The stainless steel construction resists corrosion and provides durable support. The design allows on-site height correction up to 15 mm without major disassembly, enabling precise alignment of the base/plinth system. Supplied as a set of four pieces to equip one enclosure or rack base, the component integrates with the VX corner piece for straightforward installation.

Suitable for

Key specifications

How to use

Install the leveler through the VX base/plinth corner piece at the cabinet or rack base. Adjust the component to correct unevenness at the installation site by up to 15 mm until the enclosure is level. Tighten any retaining fasteners according to the base system instructions to secure the leveler and ensure stable support for the rack or cabinet.

Recommendations

Verify compatibility with the VX base/plinth corner piece before installation. Check that the maximum levelling requirement does not exceed 15 mm. For safety and best results, follow Rittal’s assembly instructions and use appropriate tools when adjusting and securing the leveler.