Pack de tubos rígidos XSPC PETG 14/10 mm, 2x 500 mm, negro satinado

XSPC PETG rigid tubing pack 14/10 mm, 2x 500 mm, satin black is a set of two straight PETG tubes designed for custom liquid cooling loops and compatible cooling systems. Each tube measures 14 mm outer diameter and 10 mm inner diameter with a length of 500 mm, finished in satin black for a consistent, low-gloss appearance. The material is rigid PETG, offering dimensional stability and good chemical resistance for common PC coolants.

Advantages

The rigid PETG construction provides reliable shape retention and a smooth internal surface to promote consistent coolant flow. Satin black finish conceals minor scratches and provides a uniform visual appearance within a build. Tubes are supplied at industry-standard 14/10 mm dimensions to ensure compatibility with common compression fittings and adapters. PETG is straightforward to cut and form with standard tools, and it resists degradation from typical water-based coolants when used as intended.

Suitable for

• Custom PC liquid cooling loops
• Replacement or upgrade of existing rigid tubing runs
• Home or workshop assembly of radiator, pump and reservoir connections
• Systems using compression fittings compatible with 14 mm OD / 10 mm ID tubing

Key specifications

• Material: PETG (rigid thermoplastic)
• Outer diameter: 14 mm
• Inner diameter: 10 mm
• Length per tube: 500 mm
• Finish: satin black (low-gloss)
• Pack quantity: 2 tubes

How to use

Measure required lengths within the loop and mark the tubes for cutting. Use a fine-toothed saw, tubing cutter, or CNC saw to achieve square, burr-free ends. Deburr and polish cut edges if necessary to ensure a secure seal with compression fittings. For bends, use a heat source and bending tools appropriate for PETG or prepare fittings to route the tubing straight between components. Insert tubing fully into compatible compression fittings and tighten according to the fitting manufacturer’s torque recommendations to avoid overtightening.

Recommendations

Before installation, inspect each tube for surface defects or foreign particles. Flush the cooling loop and verify compatibility of coolant and additives with PETG. Allow any applied heat for bending to cool and stabilize before final assembly. Store unused tubes away from direct sunlight and solvents to preserve material properties.