Palanca (extractor de clips) KS Tools 911.8191 forma en U 230 mm acodada estrecha

KS Tools clipheber U‑Form model 911.8191 is a 230 mm angled narrow pry bar designed for precise leverage and careful prying in confined areas. The U‑shaped profile and angled narrow tip allow controlled access behind panels and around fasteners, making it suitable for automotive trim removal, clip extraction and delicate maintenance tasks where space is limited.

Advantages

The compact 230 mm length provides reach without sacrificing control, and the angled narrow tip is shaped to engage small clips and retainers with reduced risk of surface damage. The U‑form cross section adds stiffness and controlled flex for predictable force transfer. The tool is designed for repetitive use in workshop and maintenance environments and offers straightforward handling for one‑handed or two‑handed operation.

Suitable for

• Removing plastic clips and trim in automotive bodywork
• Accessing fasteners in tight or recessed areas
• Interior and exterior panel work where precise leverage is needed
• General workshop and maintenance prying tasks requiring a narrow angled tip

Key specifications

• Overall length: 230 mm
• Design: U‑shaped (U‑form) profile
• Tip: Angled narrow tip for tight‑space access
• Primary use: Pry bar / clipheber for clips, fasteners and trim
• Typical applications: Automotive, workshop, maintenance

How to use

Position the angled narrow tip of the clipheber between the clip or trim piece and the mating surface, taking care to avoid applying pressure directly to painted or delicate areas. Use steady, controlled leverage to lift or pry the fastener; the U‑form profile helps transfer force evenly. For stubborn clips, work gradually around the perimeter to reduce the risk of breakage. When necessary, support adjacent panels with a hand or secondary tool to prevent deformation.

Recommendations

For best results, use the KS Tools clipheber in combination with protective padding or a soft pry pad where cosmetic surfaces are at risk. Inspect the tool before use for deformation or excessive wear and replace if the tip is damaged to maintain safe and effective operation.