Pantalla táctil Creality 3D 4001050073 negro gris

The Creality 3D 4001050073 Touch Screen in black and grey is a compatible replacement display for supported Creality 3D printers. Designed to restore or upgrade the printer interface, this touch screen provides a responsive surface for navigating printer menus, adjusting settings, and monitoring print jobs. Its compact form and neutral colour scheme make it suitable for a range of Creality models and workshop environments.

Advantages

The touch-sensitive interface simplifies interaction with printer firmware, offering quicker access to common controls compared to rotary knobs or button-only panels. Lightweight construction reduces strain on mounting points, while the neutral black and grey finish integrates with existing printer housings. The component is intended as a direct spare part to maintain or improve the usability of a Creality 3D printer.

Key specifications

• Type: touch-sensitive display designed for 3D printer control
• Colour: black and grey housing
• Weight: approximately 0.122 kg
• Form factor: compact panel compatible with Creality printer mounts

How to use

Power off the printer and disconnect it from mains power before removing the existing display. Install the touch screen into the original display slot following the printer manufacturer’s mounting points and connector orientation. Reconnect the data and power cables securely, restore power, and verify that the printer recognizes the new display. Use the touch interface to navigate menus, select print jobs, and adjust parameters according to your printer firmware instructions.

Recommendations

Handle the display by its edges to avoid leaving fingerprints on the touch surface, and avoid exposing the screen to strong solvents or abrasive cleaners. If the display does not respond after installation, check cable connections and consult the printer firmware documentation or technical support for compatibility and calibration steps.