Sensor de gas Tellur T-MLX46896 DC 12V 1A Blanco

Tellur T-MLX46896 DC 12V 1A White is a compact gas sensor designed for integration into DC 12V systems. The sensor detects the presence of combustible or hazardous gases and provides a simple electrical interface for monitoring and alarm circuits. With a white housing and a small footprint, it fits residential and light commercial safety installations where reliable gas detection is required.

Advantages

The sensor offers plug-and-play compatibility with 12V DC power supplies and supports up to 1A current, enabling straightforward connection to auxiliary alarm modules, control panels, or monitoring devices. Its compact design and neutral white finish allow discreet mounting in indoor locations. The Tellur gas sensor provides continuous detection capability and is intended for easy integration into existing safety setups without extensive modifications.

Suitable for

• Residential gas leak detection systems
• Light commercial monitoring in kitchens and utility rooms
• Integration with alarm panels and automated shutoff mechanisms
• Local detection in garages, boiler rooms, or storage areas

Key specifications

• Operating voltage: DC 12 V
• Maximum current rating: 1 A
• Housing color: white
• Form factor: compact sensor module suitable for indoor mounting
• Detection type: gas presence detection for combustible/hazardous gases

How to use

Install the Tellur gas sensor in a location representative of potential gas accumulation, avoiding direct airflow from vents or fans that could dilute readings. Connect the sensor to a stable DC 12V power source and ensure the cabling and connectors support the 1A current rating. Integrate the sensor output into your alarm or monitoring system following the controller manufacturer’s wiring diagrams. After installation, power the sensor and observe any status indicators or reporting outputs to confirm normal operation before leaving the system unattended.

Recommendations

Perform periodic functional checks and, where available, follow any calibration or test procedures recommended by the system controller. Do not expose the sensor to direct water jets or corrosive agents. For optimum performance, install at heights and locations recommended for the target gas type and adhere to local safety codes when connecting to automated shutdown or alarm systems.