Set CableMod Dual StealthSense para Corsair RMi/RMx blanco 16 pines (2× cables)

CableMod Dual StealthSense Set for Corsair RMi/RMx White 16-pin (2× cables) provides two custom sleeved replacement cables designed specifically for Corsair RMi and RMx series power supplies. Each kit contains two white 16‑pin cables that match the connector layout used by the listed Corsair models to replace factory wiring with neatly sleeved alternatives. The set is intended for system builders and upgraders who require tidy internal routing, improved visual consistency, and a clean PSU connection without altering the original power delivery.

Advantages

The cables are sleeved to offer a uniform appearance and easier routing inside the chassis while maintaining compatibility with Corsair RMi and RMx power supplies. Using two matched 16‑pin cables simplifies cable management on systems that use dual connector layouts and reduces clutter around the PSU area. The white color provides a neutral aesthetic that integrates with light-themed builds and contrasts with darker components for clearer visibility of cable runs.

Suitable for

• Custom PC builds using Corsair RMi or RMx series power supplies
• System upgrades focused on cable management and internal aesthetics
• Modded cases where visible cable routing requires a clean, sleeved appearance
• Repair or replacement of worn or damaged 16‑pin PSU cables on compatible Corsair units

Key specifications

• Quantity: 2 cables
• Connector type: 16‑pin compatible with Corsair RMi/RMx PSU connector layout
• Color: white sleeved cables
• Purpose: replacement/custom sleeved PSU cables for tidy routing and aesthetics
• Compatibility: designed for use with listed Corsair RMi and RMx models

How to use

Power down the system and disconnect it from mains before beginning. Open the case to access the power supply area and remove the factory cables from the PSU and connected components. Align each 16‑pin connector with the corresponding PSU and motherboard headers on the compatible Corsair RMi/RMx unit and insert gently until seated. Route the sleeved cables through the case cable channels or tie points to achieve the desired layout, then reconnect and secure the case. Reconnect mains power and perform a system power-on test to confirm stable operation.

Recommendations

Verify that your Corsair RMi or RMx model is listed as compatible before installation. Handle connectors carefully to avoid bending pins and maintain proper airflow by routing cables to minimize obstruction of fans and ventilation paths.