Cable de alimentación sin marca S/CONN 09-05044 — 3 m, CEE7/7 a conector hembra C13, 230 V

Markenlos S/CONN 09-05044 is a 3 m mains power cable with a CEE7/7 plug and an IEC C13 coupler for 230 V installations. It provides a grounded connection between European wall sockets and devices that use an IEC C13 inlet, such as desktop computers, monitors, printers and small uninterruptible power supplies. The cable length allows flexible placement of equipment in office and home environments while maintaining a standard safety grounding.

Advantages

This power cable offers a standard-compliant grounded connection suitable for typical IT and consumer electronics. The 3 m length gives additional reach compared with shorter power leads, reducing the need for extension cords. The combination of a CEE7/7 mains plug and an IEC C13 coupler ensures compatibility with a wide range of European outlets and devices that use the C13 inlet. The cable is designed for 230 V operation and supports common office and home power requirements.

Suitable for

• Connecting desktop PCs and workstations to European mains sockets
• Powering monitors, printers and scanners with IEC C13 inlets
• Supplying small UPS units and network equipment
• Temporary or semi-permanent cable routing in office and home setups

Key specifications

• Cable length: 3 m
• Input connector: CEE7/7 mains plug (European grounded plug)
• Output connector: IEC C13 coupler
• Rated voltage: 230 V
• Grounded connection for safety

How to use

Insert the CEE7/7 plug into a suitable 230 V grounded wall socket and connect the IEC C13 coupler to the device's corresponding inlet. Ensure both the wall socket and the device are switched off when making the connection. Route the cable to avoid sharp bends, high-traffic areas and heat sources. After connecting, switch on the mains and then power up the connected device following its manufacturer instructions.

Recommendations

Use this cable only with devices that accept an IEC C13 input and within the cable's rated voltage. Inspect the cable periodically for damage and replace it if the insulation or connectors show wear. Avoid loading the cable beyond the current rating specified by the connected device and the local electrical standards. For permanent or concealed installations consult a qualified electrician.