Cable de red S/CONN Cat.7 0,5 m

The ShiverPeaks Networking Cable S/CONN Cat.7 0.5 m is a high-performance patch cable designed for short-range connections in structured networks. Featuring S/FTP shielding around individually foil-wrapped pairs and an overall braided shield, the cable is built to reduce crosstalk and electromagnetic interference. Equipped with RJ-45 plugs and gold-plated contacts, the 0.5 m cable provides reliable conductive contact and consistent signal transfer for demanding data applications. The clean white jacket offers a neutral appearance suitable for offices, server racks, and home network setups.

Advantages

S/FTP shielding improves signal integrity in environments with high electromagnetic noise. Gold-plated RJ-45 connectors deliver corrosion resistance and stable contact performance over extended use. The Cat.7 specification supports higher bandwidth and improved pair-to-pair isolation compared with lower categories, making the cable suitable for advanced Ethernet standards and high-speed data transmission. The short 0.5 m length minimizes excess cable in dense installations and reduces potential signal reflections.

Suitable for

• Patch connections between switches, routers and servers in racks
• Direct device-to-device connections where minimal cable slack is required
• High-performance home networks and small office setups
• Environments with potential electromagnetic interference from nearby equipment

Key specifications

• Category: Cat.7 cable supporting high bandwidth
• Shielding: S/FTP (overall braided shield with individually foil-wrapped pairs)
• Connector type: RJ-45 plugs with gold-plated contacts
• Length: 0.5 m
• Jacket color: White
• Typical application: Ethernet and data transmission for networks up to high gigabit speeds

How to use

Connect one RJ-45 plug to the network port of your switch, router, or network interface and insert the opposite plug into the target device. Ensure connectors click into place to confirm secure mating. Use the 0.5 m cable for short-distance connections where minimal slack is desired; avoid sharp bends near the connector boots and do not exceed the bend radius specified by general Ethernet cable handling guidelines to maintain performance.

Recommendations

For best results, route the cable away from large power cabling and sources of interference, maintain gentle curves rather than tight bends, and use short patch lengths like 0.5 m where rack density or minimal cable management is required. Verify compatibility with your equipment's Ethernet standard to achieve expected throughput.