Sierra de inglete Metabo KGS 305 M 3700 rpm 1600 W inglete doble

The Metabo KGS 305 M 3700 RPM 1600 W Double Bevel is a professional miter saw designed for accurate crosscuts, mitres and compound cuts. Powered by a 1600 W motor with a maximum idle speed of 3700 RPM and fitted with a 305 mm blade diameter, this double-bevel saw delivers the cutting speed and stability required for woodworking, trim work and construction tasks. The machine’s robust footprint—657 mm wide, 500 mm deep and 780 mm high—provides a stable platform for repeatable, precise cuts on boards, mouldings and panels.

Advantages

The double-bevel mechanism allows quick left and right tilt adjustments without repositioning the workpiece, increasing workflow efficiency. A high-torque 1600 W motor combined with up to 3700 RPM idle speed ensures consistent cutting power through soft and hard woods and many common panel materials. The 305 mm blade diameter provides a balance between cutting capacity and compact design, while the solid build and table dimensions enhance stability and reduce vibration for better finish quality.

Suitable for

• Crosscutting lumber and boards for framing and joinery
• Making precise mitre joints for skirting, architraves and picture frames
• Performing compound cuts for roof rafters and trim mouldings
• Cutting plywood, MDF and other sheet materials to size

Key specifications

• Motor input power: 1600 W
• Maximum idle speed: 3700 RPM
• Blade diameter: 305 mm
• Bevel capability: double bevel (left and right tilt)
• Power supply: AC mains
• Machine dimensions (W×D×H): 657 × 500 × 780 mm

How to use

Secure the saw on a stable workbench or stand and connect it to an appropriate AC power supply. Fit a suitable 305 mm saw blade for the material to be cut, tighten the blade guard and adjust the fence for the desired cut length. Set the mitre angle and, where necessary, engage the double-bevel tilt to the required left or right angle. Clamp the workpiece firmly against the fence, start the motor and allow the blade to reach full speed before making a steady downward cutting motion. After completing the cut, release the trigger and wait for the blade to stop before lifting the arm and removing the workpiece.

Recommendations

Use blades matched to the material and tooth count appropriate for fine or rough cuts; wear eye and hearing protection, and use a dust extraction system or shop vacuum connection when cutting sheet materials to reduce dust. Regularly check blade sharpness, fence alignment and fastening hardware to maintain cutting accuracy and safe operation.