SSD M.2 2280 1TB PNY PCIe 5.0 M280CS3250-1TB-TB

PNY M.2 2280 1TB PNY PCIe 5.0 M280CS3250-1TB-TB is a compact NVMe solid-state drive in the standard M.2 2280 form factor, offering 1TB of usable storage capacity and a PCIe 5.0 interface. The drive is designed for desktop and laptop systems with an available M.2 2280 slot and PCIe 5.0 support, delivering increased sequential and random transfer performance compared with PCIe 4.0 devices. Its single-sided M.2 module fits common motherboards and thin laptops while providing a balance of capacity and performance for system, application, and file storage.

Advantages

The drive provides higher bandwidth and lower latency enabled by the PCIe 5.0 interface, improving boot times, application launches, and file transfers. Its 1TB capacity allows for a full system installation plus games, media, or project files without immediate capacity constraints. The M.2 2280 form factor ensures compatibility with mainstream motherboards and many laptop models, while the NVMe protocol optimizes queue handling and sustained throughput for data-intensive tasks.

Suitable for

• Operating system and system drive for desktops and laptops with M.2 2280 PCIe slots
• Gaming installations and fast game load times
• Content creation workflows such as photo and video editing where fast scratch and working storage is needed
• Storage upgrades to replace older SATA SSDs or slower NVMe drives

Key specifications

• Form factor: M.2 2280 (single-sided)
• Interface: PCIe Gen5 (NVMe protocol)
• Capacity: 1 TB usable storage
• Controller and NAND type: manufacturer-optimized NVMe controller with high-density NAND (consumer SSD architecture)
• Typical operating temperature range suitable for consumer desktops and laptops
• Low power idle modes and active power states compatible with modern system power management

How to use

Install the M.2 2280 SSD into a compatible M.2 slot on the motherboard or laptop following the device manufacturer's installation instructions. Ensure the system BIOS/UEFI recognizes PCIe 5.0 NVMe drives and update firmware or drivers as recommended by the system or motherboard vendor. For best results, configure the drive as the system boot device or add it as secondary storage, then initialize and format it in the operating system using standard disk management tools. Handle the module by its edges and avoid contact with connector pins.

Recommendations

Use the drive in systems that support PCIe 5.0 to realize maximum performance; in PCIe 4.0 or lower slots the drive remains compatible but will operate at the lower interface speed. Keep system firmware and NVMe drivers up to date, maintain sufficient free space for internal wear leveling, and ensure adequate cooling in compact or high-load environments to sustain performance over extended workloads.