PNY Performance - DDR4 - módulo - 8 GB - SO DIMM 260-PIN

The PNY Performance DDR4 8 GB 3200 MHz memory module provides a straightforward way to upgrade a compatible notebook or small-form PC with additional system memory. This single-module DDR4 upgrade increases available RAM to 8 GB, runs at 3200 MHz with 1.2 V operating voltage and CAS latency 22, and is intended to improve responsiveness when running memory-intensive applications, multitasking with many browser tabs, or using creative tools.

Advantages

PNY Performance DDR4 modules deliver higher transfer speeds and increased bandwidth compared with older memory generations, while consuming lower power. The module is engineered and tested for stable, reliable operation in common computing environments and offers a cost-effective way to boost system performance without replacing the entire PC.

Suitable for

Key specifications

How to use

Power off the computer and disconnect it from mains power. Open the notebook or desktop access panel according to the manufacturer’s service instructions. Locate the memory slots, release existing SO-DIMM latches if necessary, and insert the PNY DDR4 module at the correct angle until it clicks into place. Reassemble the system, reconnect power, and start the computer. The operating system should recognize the additional memory automatically; confirm new total RAM in system settings or BIOS/UEFI.

Recommendations

Verify system compatibility before purchase: check your notebook or motherboard supports DDR4 SO-DIMM modules at 3200 MHz and that the maximum supported memory and slot configuration accommodate an 8 GB module. For optimal performance, match module specifications when installing in dual-channel configurations.