Switch de red PoE PULSAR S64H — 6 puertos 10/100 Mbps, soporte PoE

PULSAR S64H is a compact PoE network switch with six 10/100 Mbps Ethernet ports and integrated Power over Ethernet support. The device is intended for small network environments where both data connectivity and power delivery over a single cable are required. With straightforward switching functions and a small footprint, this PoE switch simplifies deployment of devices such as surveillance cameras, wireless access points and VoIP phones while keeping cabling and installation time to a minimum.

Advantages

The switch combines six 10/100 Mbps ports with PoE capability so connected devices receive power and data through the same cable, reducing the need for separate power supplies and outlets. Its compact design allows installation in confined spaces or equipment cabinets. Basic switching features ensure stable packet forwarding for small setups, and plug-and-play operation requires minimal configuration. The solid-state construction and standard Ethernet interfaces provide compatibility with a wide range of networked devices commonly used in small offices and residential systems.

Suitable for

• Connecting up to six PoE-enabled IP surveillance cameras
• Powering and linking wireless access points in small deployments
• Providing network and power to VoIP phones and small office devices
• Simple edge switching in compact network closets or residential installations

Key specifications

• Number of ports: 6 x 10/100 Mbps Ethernet ports
• Power over Ethernet: PoE support on relevant ports to supply connected devices
• Form factor: compact, desktop or shelf-mountable housing
• Switching mode: unmanaged/basic switching for plug-and-play operation
• Power input: external power adapter (delivers PoE to connected devices)
• Typical applications: small networks, CCTV, wireless APs, VoIP telephony

How to use

Place the PULSAR S64H on a flat surface or mount it in a small cabinet near the devices to be connected. Connect the switch to a network router or uplink using one of the Ethernet ports, then connect PoE-capable devices (cameras, access points or phones) to the remaining ports with standard Ethernet cables. Plug the external power adapter into the switch and then into mains power to enable PoE on the supported ports. The unit requires no special configuration for basic operation; once connected, devices should receive both power and network access automatically.

Recommendations

For reliable operation, use Ethernet cables of appropriate category (Cat5e or higher) and keep total cable length within standard Ethernet limits. Verify power requirements of each connected device to ensure the combined PoE budget of the switch meets demand. Place the switch in a ventilated area away from direct heat sources and moisture. If multiple high-power devices are required, consider a switch with a larger PoE budget or separate power injectors.