Synology FlashStation FS3410 - Servidor NAS - 24 bahías - 108TB - Rack - montaje - RAID 0, 1, 5, 6, 10, JBOD, RAID F1 - RAM 16GB - 10 Gigabit Ethe

The Synology DDR4 16GB ECC memory module is a single 16 GB DIMM designed for use in compatible NAS devices and storage servers. It uses DDR4 technology with ECC (Error-Correcting Code) to help detect and correct single-bit memory errors, improving data integrity and system stability under sustained loads. This module is intended as an upgrade or replacement memory for systems that support ECC DDR4 DIMMs and require reliable operation for data-intensive tasks.

Advantages

This 16 GB DDR4 ECC module delivers a balance of capacity and error-correcting functionality to reduce the risk of data corruption during read/write operations. ECC support helps maintain uptime and consistent performance in multi-user and heavy I/O environments. The single-module format makes installation straightforward in supported systems, enabling immediate memory capacity increase without changing existing configuration.

Suitable for

• Network-attached storage (NAS) devices compatible with DDR4 ECC modules
• Small to medium storage servers requiring improved data integrity
• Virtualization hosts and multi-user file servers with moderate memory demands
• Systems used for backup, media streaming, and collaborative storage workflows

Key specifications

• Memory capacity: 16 GB
• Memory type: DDR4
• Error correction: ECC (Error-Correcting Code)
• Module format: single DIMM module (single-rank layout)
• Compatibility: designed for NAS and storage server environments supporting ECC DDR4

How to use

Power down the target NAS or server and disconnect it from power before installation. Open the memory compartment or chassis according to the device manufacturer's instructions. Align the module with the DIMM slot, ensuring the notch matches the slot key, then press firmly and evenly until the retention clips engage. Reassemble the chassis, reconnect power, and boot the system. Verify that the new memory is recognized in the system firmware or management interface and that ECC functionality is enabled where applicable.

Recommendations

Install this module only in systems that explicitly support DDR4 ECC memory; mixing ECC and non-ECC modules or incompatible configurations can prevent ECC operation. For best results in multi-module systems, install memory in matched pairs or according to the motherboard or NAS vendor's guidelines. Regularly check system logs and firmware updates to ensure ongoing compatibility and stability.