Tarjeta gráfica Palit GeForce RTX 5050 StormX OC — 8 GB GDDR6, 128 bits, PCIe 5.0

Palit GeForce RTX 5050 StormX OC is a compact discrete graphics card based on the NVIDIA GeForce RTX 5050 GPU with a boost core frequency of up to 2317 MHz. The card integrates 8 GB of GDDR6 memory on a 128-bit bus and connects via the PCI Express 5.0 interface. Designed for small form factor systems, it supports resolutions up to 7680×4320, DirectX 12 Ultimate and OpenGL 4.6, and delivers hardware-accelerated ray tracing, AI-powered features and modern media encode/decode capabilities.

Advantages

The StormX OC model combines a 17 cm compact PCB and an efficient single-fan cooling solution that keeps thermal and acoustic output low under light loads while providing active cooling when required. Built on NVIDIA Blackwell architecture, it supports advanced ray tracing, DLSS AI upscaling and low-latency technologies to improve frame rates and responsiveness. The card offers a balanced specification for gaming, content creation and multimedia in space-constrained enclosures.

Suitable for

• Compact gaming builds and small form factor desktops
• Casual and competitive gaming at 1080p and some 1440p settings with AI upscaling
• Video playback, streaming and multimedia workflows
• Entry-level content creation, video editing and 3D previewing

Key specifications

• Graphics processor: GeForce RTX 5050 with up to 2317 MHz core frequency
• Memory: 8 GB GDDR6 on a 128-bit memory bus
• Interface: PCI Express 5.0
• Maximum supported display resolution: up to 7680×4320
• API support: DirectX 12 Ultimate, OpenGL 4.6
• Display outputs: one HDMI and three DisplayPort connectors
• Power connector: single 8-pin external power input
• Cooling: single active fan with composite heat pipe and enhanced thermal materials

How to use

Install the Palit GeForce RTX 5050 StormX OC into an available PCIe x16 slot on a compatible motherboard and connect the required 8-pin power cable from the system power supply. Ensure the system BIOS and operating system are up to date before installing the latest drivers from the manufacturer or NVIDIA. After hardware installation and driver setup, configure display settings and preferred GPU features through the NVIDIA control panel or Palit ThunderMaster utility for monitoring, fan control, overclocking and LED adjustments.

Recommendations

For stable operation in small form factor builds, verify chassis airflow and use a power supply that meets the card’s power requirements. Enable DLSS or other AI upscaling features when targeting higher frame rates at 1440p or 4K. Use ThunderMaster to monitor temperatures and adjust fan curves; the fanless idle mode reduces noise when the GPU load is low but relies on adequate case ventilation during heavier loads.