Termostato Heatit Z-TRM6 Negro Mate — Z-Wave 868,4 MHz, 16A (3600W)

The Heatit Z-TRM6 Black Matt is a Z-Wave enabled room thermostat designed to control electric heating loads up to 16A (3600W) on the 868.4 MHz frequency. The device features a matte black finish and provides accurate temperature regulation for floor heating, convectors and other electric heaters. By integrating with Z-Wave smart home networks, it supports scheduled operation and remote control through compatible gateways and controllers, allowing centralized management of room climate.

Advantages

The thermostat offers reliable temperature control with support for a maximum load of 16A (3600W) and compatibility with Z-Wave 868.4 MHz networks for seamless smart home integration. Its Black Matt finish is designed for discreet installation in modern interiors, while the Z-Wave interface enables remote setpoint changes, scheduling and scene integration. Built for electric heating applications, the unit provides stable output switching and works with floor sensors or room sensors, depending on installation needs.

Suitable for

• Electric underfloor heating systems
• Wall-mounted convectors and panel heaters
• Individual room temperature control in smart homes
• Integration into Z-Wave automation scenes and schedules

Key specifications

• Wireless protocol: Z-Wave at 868.4 MHz
• Maximum switching current: 16A (3600W)
• Control type: room thermostat for electric heating
• Finish: Black Matt
• Compatibility: designed for integration with Z-Wave controllers and gateways

How to use

Install the thermostat following local electrical regulations and mount it in a suitable location for representative room temperature measurement, avoiding direct sunlight and drafts. Connect the heating load and, if applicable, a floor or room sensor according to the wiring diagram supplied by the manufacturer. Include the thermostat into a Z-Wave network via the primary controller to enable remote control and scheduling. Set desired temperature setpoints and create schedules or scenes in the controller interface to automate operation.

Recommendations

For accurate temperature control, position the thermostat where it measures ambient room temperature rather than direct heat sources. Use a compatible floor sensor when controlling underfloor heating to prevent overheating of floor surfaces. Ensure the connected heating load does not exceed 16A (3600W) and verify compatibility with your Z-Wave controller for full feature access.

Heatit Z-TRM6 Black Matt — Z-Wave 868.4 MHz, 16A (3600W)