Transceptor SFP BlueOptics 10G-SFP-ER-BO 10000 Mbit/s SFP+

The BlueOptics 10G-SFP-ER-BO 10000 Mbit/s SFP+ is a fiber optic SFP+ transceiver module designed for 10 Gigabit Ethernet links over single-mode fiber. The module supports a maximum data rate of 10,000 Mbit/s and follows standard SFP+ form factor dimensions for compatibility with a wide range of network switches and routers. It is finished in a silver housing, weighs approximately 20 g, and is specified with a mean time between failures (MTBF) of 1,000,000 hours. The device complies with CE, FCC and RoHS directives, which indicates conformity with relevant safety, electromagnetic compatibility and environmental requirements.

Advantages

The SFP+ transceiver provides a standardized interface for high-speed optical connectivity and allows straightforward hot-plug installation into compatible SFP+ ports. Its compact SFP+ form factor conserves space in chassis and networking equipment while delivering 10 Gbit/s throughput. A long MTBF rating signals durable operation under normal conditions, and regulatory compliance ensures it meets common industry requirements for safety and emissions.

Suitable for

• Establishing 10 Gigabit Ethernet links over single-mode fiber
• Upgrading SFP+ ports in data center and enterprise switches
• Interconnecting routers, servers and storage systems requiring 10 Gbit/s optical uplinks
• Deployments where CE, FCC and RoHS compliance is required

Key specifications

• Form factor: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Connection medium: fiber optic (single-mode)
• Housing colour: silver
• Weight: approx. 0.02 kg
• Reliability: MTBF 1,000,000 hours
• Standards compliance: CE, FCC, RoHS

How to use

Install the BlueOptics 10G-SFP-ER-BO by inserting the module into a compatible SFP+ slot until it latches; ensure the host device is powered and configured to recognize the transceiver. Connect single-mode fiber optic cables with appropriate connectors to the module's optical port, observing proper cable polarity. Verify link status and configure network settings (speed, duplex, and any vendor-specific options) on the hosting switch or router. Handle the transceiver and fiber connectors with care to avoid contamination; use protective caps when ports are not connected.

Recommendations

For reliable long-distance 10 Gbit/s links, use certified single-mode fiber and keep optical connectors clean. Confirm compatibility with the host device's SFP+ port and firmware; where necessary, check vendor documentation for supported transceiver models. Store and operate the module within the manufacturer's recommended temperature and humidity ranges to maintain MTBF expectations.