Transceptor SFP BlueOptics 3FE25776AA-BO 1250 Mbit/s fibra óptica

The BlueOptics 3FE25776AA-BO SFP transceiver is a single-slot fiber optic module designed for 1000BASE-ZX applications with a maximum data transfer rate of 1250 Mbit/s. Housed in a silver metal enclosure and weighing approximately 20 g, this SFP module follows MSA mechanical standards and provides a compact, industry-standard form factor for use in compatible network equipment. The module supports single-mode fiber connections using an LC duplex connector and is intended for reliable long-distance optical links where electromagnetic immunity and stable bandwidth are required.

Advantages

This SFP transceiver offers a durable metal housing and a lightweight design that simplifies installation and handling. It is manufactured to meet common MSA interoperability requirements, enabling compatibility with a wide range of network platforms that accept MSA-compliant SFP modules. The module is specified with a high mean time between failures (MTBF) of 1,000,000 hours, indicating extended operational lifetime for reduced maintenance intervals.

Suitable for

• Long-distance gigabit Ethernet links over single-mode fiber
• Optical uplinks between switches and routers
• Fibre Channel over Ethernet or SDH/SONET applications up to 1.25 Gbit/s
• Environments requiring low electromagnetic interference susceptibility

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Connector type: LC duplex (single-mode fiber)
• Housing: metal, silver colour
• Weight: 0.02 kg
• Typical application range: long-reach single-mode optical links (up to tens of kilometres depending on system)

How to use

Install the BlueOptics SFP transceiver into an available SFP slot on compatible network equipment, ensuring the host device supports SFP modules and the required optical standard. Connect an LC duplex single-mode fiber patch cord to the module’s ports, observing correct TX/RX orientation. Verify link status and, if supported by the host, enable Digital Diagnostic Monitoring (DDM/DOM) to observe operating parameters such as optical power and temperature. Follow the equipment vendor’s procedures for hot-plugging or powering down when required.

Recommendations

Use appropriate single-mode LC duplex patch cords and quality connectors to achieve the best optical performance. Confirm compatibility with the host device firmware or vendor list when precise interoperability is required. Maintain clean fiber endfaces and follow ESD precautions during handling and installation.