Transceptor SFP+ BlueOptics 44W4404 fibra óptica 10000 Mbit/s 850 nm

The BlueOptics 44W4404 is an SFP+ fiber optic transceiver module designed for reliable short-range high-speed links. Supporting a maximum data transfer rate of 10,000 Mbit/s and operating at an 850 nm wavelength, this compact silver module provides a straightforward solution for upgrading or extending network ports that require SFP+ connectivity. The transceiver's lightweight construction (approx. 20 g) and industry-standard SFP+ interface make it compatible with a wide range of switches, routers and host adapters that accept SFP+ form-factor modules.

Advantages

The module supports 10 Gbps data throughput over multimode fiber at 850 nm, enabling low-latency short-reach connections. Its SFP+ interface ensures hot-pluggable installation and broad interoperability with equipment designed for SFP+ optics. The small, silver housing offers a compact footprint and easy handling, while the modest weight simplifies installation within dense networking racks.

Suitable for

• Short-range 10 Gbps links in data centers and server rooms
• Connections between switches and routers supporting SFP+
• Upgrading server NICs or host adapters to 10 Gbit/s multimode fiber
• High-speed links in campus and enterprise networks over multimode fiber

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbps)
• Wavelength: 850 nm
• Form factor: SFP+ optical transceiver
• Typical application: short-range multimode fiber links
• Colour: silver
• Weight: 0.02 kg (approx.)

How to use

Install the BlueOptics 44W4404 by inserting the transceiver into an available SFP+ slot on a compatible switch, router or host adapter until it clicks into place. Connect appropriate multimode fiber cabling and LC connectors to the transceiver, ensuring correct polarity. Configure the network device as needed to recognize a 10 Gbps link and verify link status through device management interfaces or LEDs. When removing the module, power down or follow hot-swap procedures recommended by the equipment vendor if required.

Recommendations

Use multimode fiber rated for short-range 10 Gbps transmission and ensure LC connectors are clean to maintain signal integrity. Confirm compatibility with your network equipment's SFP+ port firmware and supported optical specifications before deployment.