Transceptor SFP BlueOptics JW088A-BO 1250 Mbit/s 850 nm plateado

The BlueOptics JW088A-BO SFP transceiver is a compact fiber-optic module designed for 1.25 Gbit/s multimode links using an 850 nm wavelength. Housed in a silver SFP package and weighing approximately 20 g, the module offers a standardized small form-factor pluggable interface (SFP) for insertion into compatible switch, router or storage system ports. The transceiver is RoHS and CE compliant and supports optical transmission over multimode fiber with LC duplex connectivity according to MSA-compatible SFP specifications.

Advantages

This BlueOptics SFP transceiver supports up to 1250 Mbit/s data rate at 850 nm, enabling gigabit optical connections over multimode fiber. Its SFP form factor and MSA-compliant design ensure mechanical and electrical interoperability with many network devices that accept standard SFP modules. The small size and light weight simplify handling and installation, while CE and RoHS compliance addresses regulatory and environmental requirements.

Suitable for

• Gigabit Ethernet links over multimode fiber
• Data center uplinks between switches and servers
• Short-range optical connections within campus or enterprise networks
• Replacement or upgrade of standard SFP 850 nm ports

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s (1.25 Gbit/s)
• Optical wavelength: 850 nm (multimode)
• Connector type: LC duplex (MSA-compatible)
• Typical application: 1000Base-SX / gigabit optical links
• Weight: 0.02 kg
• Colour: Silver
• Compliance: RoHS, CE

How to use

Install the transceiver by inserting the SFP module into a compatible SFP port until it clicks into place, observing the device manufacturer’s hot-plug and ESD handling instructions. Attach LC duplex multimode fiber patch cords matching the 850 nm multimode specification and ensure proper polarity. Configure the host device for the intended network protocol (for example, enabling the appropriate gigabit Ethernet interface). Verify link status and perform any required device-level diagnostics or firmware settings as needed.

Recommendations

Use multimode fiber rated for short-range 850 nm transmission and high-quality LC duplex patch cords to achieve specified reach and signal integrity. Confirm that the target hardware supports SFP transceivers and, if needed, DDM/DOM features for optical diagnostics. Observe ESD precautions and avoid touching the fiber endfaces; clean connectors before insertion to maintain optimal optical performance.