Transceptor SFP BlueOptics LACGLX-BO 1250 Mbit/s LC plateado

The BlueOptics LACGLX-BO SFP transceiver is a compact fiber optic module designed for single-mode networks requiring an LC interface and up to 1250 Mbit/s data rate. Housed in a silver form factor and weighing approximately 20 g, this SFP plug-in unit follows common MSA mechanical standards and is intended for use in compatible switches, routers and other network devices that accept LC SFP modules. The module transmits and receives optical signals via LC duplex connections and is suitable for point-to-point links within the supported optical reach of the installed fiber.

Advantages

The module offers a standardized LC interface and a 1250 Mbit/s maximum data transfer rate for gigabit-class optical links while maintaining a small, lightweight form factor that simplifies installation and inventory handling. Its silver housing and MSA-compatible design enable broad interoperability with devices that support LC SFP transceivers. The compact size and low weight reduce mechanical strain on transceiver cages and support straightforward hot-plug replacement.

Key specifications

How to use

Insert the BlueOptics LACGLX-BO SFP module into a compatible SFP cage on your network device while the device is powered according to the manufacturer's hot‑swap guidance. Connect LC patch cords to the transmit and receive ports ensuring correct orientation for duplex links. Verify link status through the host device interface and configure the relevant port settings (speed, duplex, optical diagnostics) as required by your network environment. If your hardware supports digital diagnostics, enable and monitor the available optical parameters through the device management interface.

Recommendations for use

To achieve optimal optical performance, use single‑mode LC fiber patch cords of appropriate attenuation and maintain clean connector endfaces. Confirm that the target device supports the SFP electrical and diagnostic interfaces required for full functionality. For critical links, test the module in your hardware before wide deployment and monitor link parameters to detect degradation over time.