Transceptor SFP BlueOptics SFP-25G-MR-XSR-BO 25000 Mbit/s 850 nm

The BlueOptics SFP-25G-MR-XSR-BO is a compact fiber optic SFP transceiver supporting data rates up to 25,000 Mbit/s with an 850 nm wavelength for short-range multimode fiber links. Designed to the SFP form factor and equipped with an LC duplex interface, the module supports simultaneous transmit and receive operation and is suitable for integration into networking equipment that accepts SFP modules. The transceiver is finished in silver, weighs approximately 20 g, and is specified with a mean time between failures (MTBF) of 1,000,000 hours for reliable long-term operation.

Advantages

The module supports high-speed 25G optical links over multimode fiber and complies with MSA SFP physical and optical interface conventions, enabling straightforward interoperability with compatible switches, routers and storage systems. Built with standardized LC duplex connectivity and designed for short-reach 850 nm transmission, the transceiver enables low-latency, EMI-immune optical connections. Digital Diagnostic Monitoring (DDM / DOM) support allows real-time monitoring of supply voltage, laser bias current, output power, received power and temperature when the host hardware provides the interface.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP-25G-MR-XSR-BO into any compatible SFP port on a switch, router or storage device while the host is powered down or following the vendor-recommended hot-plug procedure. Connect an LC duplex multimode fiber patch cable to the module's connector pair, ensuring correct transmit-to-receive alignment. Verify link negotiation and speed on the host device; enable Digital Diagnostic Monitoring on the host if you need real-time status reporting. Follow equipment vendor guidance for firmware or compatibility settings if required.

Recommendations

Use high-quality multimode fiber patch cords and maintain clean fiber endfaces to achieve optimal link performance. Confirm hardware compatibility and DDM support with the equipment manufacturer before deployment, and follow standard ESD precautions when handling the transceiver.