Transceptor SFP de cobre BlueOptics FS-TRAN-SFP+GC 10000 Mbit/s

The BlueOptics FS-TRAN-SFP+GC is a copper SFP transceiver module engineered for reliable high-speed data transfer. With an SFP+ interface and support for up to 10000 Mbit/s, this module is designed to provide consistent wired connectivity in dense network environments where short-range copper links are required. The compact SFP+ form factor ensures compatibility with a wide range of switches, routers and server NICs that accept hot-pluggable transceiver modules.

Advantages

The module offers a standardized SFP+ interface for straightforward installation and interoperability with compatible networking equipment. Its support for 10000 Mbit/s enables use in 10 Gigabit Ethernet links over copper cabling where appropriate. The copper SFP design eliminates the need for optical transceivers and fibers for short-distance links, simplifying cabling and reducing component variety in rack deployments.

Suitable for

• 10 Gigabit Ethernet connections over copper where compatible ports are available
• Server-to-switch or switch-to-switch short-range links in data centers
• Upgrading or expanding network interfaces on compatible switches, routers and network appliances
• Environments that favor copper cabling for cost or existing infrastructure reasons

Key specifications

• Form factor: SFP+ (small form-factor pluggable enhanced)
• Interface: SFP+ electrical copper
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Media type: copper (suitable for short-range copper links)

How to use

Insert the BlueOptics SFP+ copper transceiver into a compatible SFP+ port while the host equipment is powered according to the manufacturer's hot-plug guidelines. Ensure the receiving device supports copper SFP+ modules and set up the network port configuration (speed, duplex, auto-negotiation) as required by your equipment. Connect the copper cable to the transceiver and verify link status and negotiated speed in the device management interface or via status LEDs. For best results, use cabling and patch panels rated for 10 Gbit/s copper connections and confirm compatibility with your switch or NIC vendor.

Recommendations

Verify compatibility with the specific switch or router model before deployment and confirm that firmware or driver versions on both ends support SFP+ copper modules. Use high-quality, shielded copper cables certified for 10 Gbit/s to maintain signal integrity and reduce electromagnetic interference. Handle the module following ESD precautions and store unused modules in protective anti-static packaging.