Transceptor SFP de fibra óptica BlueOptics PLRXPL-VI-S24-22-BO LC aluminio 20 g

The BlueOptics PLRXPL-VI-S24-22-BO is a fiber optic SFP transceiver designed for high-speed multimode links. It uses an LC duplex connector and operates at 850 nm for both transmitter and receiver, supporting standard 1000Base-SX optical Ethernet protocols. Housed in an aluminium enclosure and weighing approximately 20 g, this SFP module follows MSA-compatible mechanical and electrical specifications and is intended for use in network equipment that supports 1000Base-SX SFP modules. The module is provided with a five-year warranty for manufacturing coverage.

Advantages

The transceiver provides stable gigabit optical transmission over multimode fiber with a typical maximum reach of up to 550 meters under standard conditions. Its compact SFP form factor and LC duplex interface make it compatible with a wide range of switches, routers and storage systems that accept MSA-compliant modules. The aluminium housing offers mechanical durability and thermal conduction while the lightweight design simplifies installation and handling. Where supported by host hardware, the module offers Digital Diagnostic Monitoring (DDM/DOM) to report supply voltage, laser bias current, transmit output power, receive input power and temperature in real time.

Suitable for

Key specifications

How to use

Install the SFP transceiver into a compatible SFP port on network equipment with the module ejector or push mechanism until it locks into place. Connect LC duplex multimode fiber patch cords to the module, ensuring correct transmit-to-receive orientation and clean fiber endfaces to avoid signal loss. Confirm that the host device supports 1000Base-SX SFP modules and, if required, enable or verify DDM/DOM monitoring in the device management interface. Observe electrostatic discharge (ESD) precautions during handling and keep protective caps on the optical ports until connection.

Recommendations

Use OM3/OM4 multimode fiber for best margin at longer distances, maintain clean connector endfaces and ensure the host hardware firmware supports third-party SFP modules and DDM/DOM functions for full diagnostics. Store and operate the module within the manufacturer’s recommended temperature and humidity ranges and request a sample or compatibility test when integrating into critical infrastructure.