Tubo de EPDM blando XSPC 13/10 mm (DI 10 mm / DE 13 mm), 2 m, negro

Soft EPDM Tubing XSPC 13/10 mm (ID 10 mm / OD 13 mm), 2 m, black is a flexible, soft-walled tube designed for liquid cooling loops and general fluid transfer in PC water-cooling systems. Manufactured from EPDM rubber, the tubing provides a balance of elasticity and dimensional stability, with an inner diameter of 10 mm and an outer diameter of 13 mm. This 2-meter length in black integrates with fittings and clamps designed for 13/10 mm tubing and is suitable for routing coolant between radiators, pumps, reservoirs and blocks.

Advantages

The EPDM material offers good flexibility and resistance to kinking while maintaining a consistent internal diameter for unobstructed coolant flow. Its soft-wall construction simplifies installation on push-fit and compression-style fittings, and the black finish conceals discoloration or deposits over time. The tubing is compatible with typical PC water-cooling fluids when used according to manufacturer guidance and provides reliable performance for extended routing runs.

Suitable for

• Custom PC liquid cooling loops, including connections between radiators, pumps, reservoirs and water blocks
• Coolant routing in compact and full-size computer cases where flexible tubing is required
• General low-pressure fluid transfer applications compatible with EPDM rubber

Key specifications

• Material: EPDM rubber
• Inner diameter: 10 mm
• Outer diameter: 13 mm
• Length: 2 m
• Color: black
• Wall type: soft/flexible

How to use

Cut the tubing to the required length using a sharp tubing cutter to ensure a clean, square end. Slide the tubing onto compatible fittings until fully seated; for compression fittings tighten according to the fitting manufacturer’s instructions and for push-fit fittings ensure a firm push until the tube is secured. Route the tubing to avoid sharp bends that exceed its bend radius and use clamps or clips where appropriate to prevent movement. Flush the loop and perform leak testing before full operation.

Recommendations

Use coolants and additives that are listed as compatible with EPDM. Avoid prolonged contact with solvents, strong acids or bases that can degrade rubber. Periodically inspect the tubing for softening, swelling or discoloration and replace if signs of deterioration appear.