Unidad de fusión CoreParts MSP0202 para impresora láser HP, 434×234 mm, 1,53 kg

The CoreParts MSP0202 fuser unit is a replacement fuser component compatible with a range of HP laser printers. Designed to fuse toner onto paper reliably, this unit has dimensions of 434 × 234 mm and a weight of 1.53 kg. Supplied as a single pack, the fuser unit restores proper heat and pressure functionality required for consistent, smear-free laser prints and helps maintain overall print quality and device uptime.

Advantages

This replacement fuser unit provides heat and pressure stability to ensure toner adhesion and reduce the risk of smearing or ghosting. Manufactured to match the performance of original equipment, it supports consistent print output and can extend the service life of the printer when installed properly. The unit is tested for compatibility with laser print engines and is offered with a standard reliability assurance period.

Suitable for

• Replacing a worn or damaged fuser in compatible HP laser printers
• Maintaining print quality in office and home laser devices
• Preventing toner smearing and paper jams caused by fuser failure
• Service and repair operations for laser printers

Key specifications

• Technology: Laser fuser unit
• Physical dimensions: 434 × 234 mm
• Weight: 1.53 kg
• Pack quantity: 1 piece
• Compatibility: Designed for use with compatible HP laser printers
• Origin: manufactured in China

How to use

Power off and unplug the printer before attempting replacement. Allow the printer to cool if it has been in use. Open the printer access panels according to the device service manual, remove the existing fuser assembly following all safety instructions, and install the CoreParts MSP0202 fuser unit in the correct orientation until it seats securely. Reassemble panels, reconnect power and run a test print to verify proper fusing and alignment. Dispose of the removed unit in accordance with local electronic waste regulations.

Recommendations

For reliable operation, use the fuser unit within the environmental conditions specified by the printer manufacturer, avoid forcing connectors or fasteners during installation, and perform a test page after replacement to confirm temperature and pressure settings produce smear-free output.