Unidad SSD SanDisk Ultra 3D 1 TB 2,5" SATA III SDSSDH3-1T00-G26

The SanDisk Ultra 3D 1 TB 2.5" SATA III SSD (SDSSDH3-1T00-G26) is a high-performance internal drive designed to accelerate PC boot-up, application loading and file transfers. Built with 3D NAND and nCache 2.0 technologies, this 1 TB 2.5" SSD delivers sequential read speeds up to 560 MB/s and write speeds up to 520 MB/s, while offering lower power consumption and solid-state durability without moving parts.

Advantages

This SanDisk Ultra 3D SSD provides faster system responsiveness, reduced application and game load times, and improved file transfer speeds. Its 3D NAND architecture and nCache 2.0 enable fast burst performance and enhanced endurance, while the solid-state design resists shock and vibration to help protect stored data. The drive is also energy-efficient, which can extend laptop battery life, and is supported by SanDisk SSD Dashboard software for cloning, drive monitoring and firmware alerts.

Suitable for

• Upgrading laptop or desktop storage to improve boot and app load times
• Everyday computing: web browsing, office apps, media playback
• Photo and video editing that benefits from faster read/write speeds
• Replacing an HDD to achieve quieter, cooler operation and better reliability

Key specifications

• Model: SanDisk Ultra 3D SDSSDH3-1T00-G26
• Capacity: 1000 GB (1 TB)
• Form factor: 2.5" SATA III
• Interface data rate: 6 Gbit/s (SATA III)
• Sequential read speed: up to 560 MB/s
• Sequential write speed: up to 520 MB/s

How to use

Install the 2.5" SanDisk Ultra 3D SSD into a compatible SATA III bay in your laptop or desktop following the device manufacturer’s instructions. Use the included or downloadable cloning software from the SanDisk SSD Dashboard to migrate your operating system and data from an existing drive, or perform a fresh OS installation. After installation, run the SanDisk SSD Dashboard to verify drive health, check performance metrics and apply firmware updates if available.

Recommendations

For best results, connect the SSD to a native SATA III (6 Gbit/s) port and ensure your system BIOS/UEFI is set to AHCI mode. Use the SanDisk SSD Dashboard for cloning, monitoring and firmware updates, and maintain regular backups of important data.