Vivolink PRODPHDMIOP50 Adaptador de cable de vídeo 20 m DisplayPort HDMI Negro

The Vivolink PRODPHDMIOP50 is a 20 m active optical DisplayPort-to-HDMI video cable adapter that connects DisplayPort source devices to HDMI displays. Combining fiber-optic and copper conductors, it supports resolutions up to 4K@60Hz while minimising signal loss over long distances. The cable is lightweight, flexible and features an ultra-small bend radius, making it suitable for a wide range of installations and AV setups.

Advantages

This active optical cable maintains high-quality video transmission across long runs by using fiber for the signal path and copper where required for power and control. It supports 4K@60Hz, reduces electromagnetic interference compared with full-copper cables, and its small diameter and low weight simplify routing and mounting in tight spaces.

Suitable for

• Connecting PCs or workstations with DisplayPort output to HDMI monitors, TVs or projectors
• Lecture halls, conference rooms and boardrooms requiring long cable runs
• AV installations where minimal signal degradation over distance is required

Key specifications

• Length: 20 m
• Connectors: DisplayPort (source) to HDMI (display)
• Supported resolution: up to 4K@60Hz
• Cable diameter: 7.3 mm
• Weight: 100 g
• Technology: active optical with combined fiber and copper cores
• Manufacturer: VivoLink, MPN PRODPHDMIOP50, EAN 5715063196830

How to use

Connect the DisplayPort end to the source device and the HDMI end to the display. Ensure both devices are powered on and set the display input to the HDMI port. The active cable requires no external power in typical configurations; if the source or display fails to negotiate a signal, verify connector seating and try a different HDMI input or DisplayPort output. For best performance, avoid sharp bends near the connectors and keep the cable clear of high-power electrical equipment.

Recommendations

Route the cable with gentle curves respecting its ultra-small bend radius, secure it with non-compressive clips, and avoid tight loops. For permanent installations, test the link at the intended resolution (4K@60Hz) before finalising cable routing.