2-power 2P-IN4V16GNGRTI - 16 GB - 1 x 16 GB - DDR4 - 3200 MHz

When a desktop workstation in a busy office starts crawling under the weight of multiple spreadsheets, browser tabs, and line-of-business applications, the usual culprit is insufficient memory. The 2-POWER 2P-IN4V16GNGRTI 16GB DDR4 module steps in as a straightforward upgrade that restores responsive multitasking without replacing the entire machine. Built around a 288-pin DIMM form factor, this single 16GB stick runs at 3200MHz with a CAS latency of 16, delivering the bandwidth modern processors expect for everyday productivity and light content creation.

Key specifications

• Capacity: 16GB (1 x 16GB)
• Memory type: DDR4
• Speed: 3200MHz (PC4-25600)
• Form factor: 288-pin DIMM
• CAS latency: CL16
• Voltage: 1.2V
• Error correction: Non-ECC
• Buffering: Unbuffered
• Rank: Single rank (1Rx8)
• Application: Desktop PC
• Heat spreader: No
• Product colour: Green PCB
• JEDEC standard: Yes
• Module height: Standard profile

Why choose it

This module follows JEDEC reference specifications, which means it plugs into any desktop board that accepts standard DDR4 UDIMMs without requiring XMP profiles or manual tuning. The 1.2V operating voltage keeps power draw and heat generation low, while the single-rank configuration can improve signal integrity on certain motherboards. For IT departments and system builders, the green PCB and lack of a heat spreader keep the module compatible with compact cases and CPU coolers that overhang the memory slots.

Ideal use cases

• Upgrading office desktops from 8GB to 16GB for smoother multitasking
• Building or refreshing budget-friendly productivity PCs
• Adding memory to home office systems used for video calls, documents, and web research
• Replacing failed memory in pre-built desktops that require standard DDR4 UDIMMs

Good to know

Because the module is unbuffered and non-ECC, it is intended for consumer and business desktop platforms rather than servers or workstations that require registered or error-correcting memory. Always verify that your motherboard supports 16GB modules and DDR4-3200 speeds; the module will downclock automatically if the board or CPU memory controller specifies a lower frequency. Installation takes only a few minutes: press the module firmly into the DIMM slot until the side clips snap into place.