Accesorio para sistema de refrigeración de PC BitsPower BP-DW45R2I – racor de latón blanco

BitsPower BP-DW45R2I – brass white fitting is a liquid-cooling system accessory designed for custom PC water loops. Manufactured from brass with a white finish, this 45° angled G1/4" fitting offers corrosion-resistant construction and a clean visible appearance for windowed cases. One end features a 360° rotary connector so the fitting can be tightened securely while allowing final orientation to be adjusted without twisting the tubing, helping to prevent kinks and maintain steady coolant flow.

Advantages

The brass construction provides durability and long-term resistance to corrosion, while the white finish gives a consistent visual style in themed builds. The 45° angle simplifies routing in tight spaces and reduces stress on soft tubing. The 360° rotary end enables convenient alignment after installation, improving leak safety and reducing the need to bend tubing to achieve the desired path. The G1/4" thread is a common standard for water-cooling components, ensuring broad compatibility with radiators, blocks, and other fittings.

Suitable for

• Custom PC water-cooling loops with soft tubing
• Tight internal case areas where directional change is required
• Visible builds where matching white fittings enhance aesthetics
• Connections to radiators, CPU/GPU blocks, and reservoirs using G1/4" threads

Key specifications

• Material: brass with white finish
• Thread standard: G1/4"
• Angle: 45°
• Rotary end: 360° swivel for final orientation
• Intended use: liquid-cooling fittings for PC systems

How to use

Install the fitting by hand-starting the G1/4" thread into the port on your radiator, block, or reservoir, then tighten with an appropriate wrench until snug—avoid over-torquing brass threads. Once the fitting is secure, rotate the 360° swivel end to orient the outlet at the desired angle for your tubing run. Slide soft tubing over the barb or compression portion (depending on design), and secure with appropriate clamps or the included compression ring. Verify all connections are tight and perform a leak test with system power off and external pump or fill setup before full operation.

Recommendations

Use compatible G1/4" ports and components, avoid excessive force when tightening to prevent thread damage, and perform a pressure or leak test after assembly. For best visual results, match the fitting finish with other visible hardware and route tubing to minimize bends and maintain optimal flow.