BitsPower Artemis Advanced Multi-Link, 14 mm de diámetro exterior, conectores Multi-Link Arctic White

BitsPower Artemis Advanced Multi-Link is a multi-link fitting system with a 14 mm outer diameter designed for custom liquid cooling loops. The Arctic White finish gives a uniform look for visible tubing runs while the multi-link architecture allows several segments to be connected in a compact arrangement. This fitting is intended for use where precise connector alignment and neat routing of soft or semi-rigid tubing are required in PC water-cooling circuits.

Advantages

The multi-link design enables compact, multi-segment connections that reduce tubing stress and improve aesthetic uniformity. A 14 mm outer diameter provides compatibility with common tubing thicknesses used in custom loops while maintaining a low-profile connection point. The Arctic White surface finish offers consistent color matching across visible fittings and helps create a coordinated build appearance. The construction is aimed at providing stable, leak-resistant joints when installed with appropriate tubing and seals.

Suitable for

• Custom PC liquid cooling loops that require compact multi-segment connections
• Builds where precise connector alignment and clean tubing routing are important
• Visible loop sections where a consistent Arctic White aesthetic is desired
• Systems using soft or semi-rigid tubing compatible with a 14 mm outer-diameter fitting

Key specifications

• Outer diameter: 14 mm
• Finish: Arctic White
• Type: Multi-link fitting system for liquid cooling
• Application: PC water-cooling tubing connections and routing
• Compatibility: Designed for soft and semi-rigid tubing sizes that seat on a 14 mm outer-diameter connector

How to use

Prepare tubing by cutting squarely and ensuring the tube end is free of burrs or deformation. Slide the tubing onto the fitting until it seats against the stop, and secure with the appropriate clamp or retention mechanism recommended for your tubing type. Arrange the multi-link segments to achieve the desired routing and alignment, ensuring each link is tightened or locked according to the manufacturer’s instructions to create a stable, leak-resistant joint. Perform a leak test at low pressure before powering the system.

Recommendations

Use tubing rated for custom loop applications and compatible with a 14 mm outer-diameter connector. Inspect seals and clamps during assembly, and follow standard water-cooling best practices such as pressure/leak testing and periodic maintenance to maintain performance and prevent leaks.