ACT 2 m SFP+ - SFP+ Cable DAC Twinax pasivo codificado para HP / HPE / Aruba / Procurve (J9282A/J9282B/J9282D)

The ACT 2 m SFP+ Passive DAC Twinax cable is a 2-meter direct-attach copper cable designed for high-speed short-range connections between network devices. It has SFP+ connectors on both ends and is compatible with HP, HPE, Aruba and Procurve models J9282A, J9282B and J9282D. The cable provides a cost-effective, low-latency option for interconnecting switches, servers and storage in data centers and network racks.

Advantages

ACT DAC (AOC) cables are manufactured to provide consistent quality and compatibility with A-brand equipment. The passive Twinax design offers plug-and-play installation with minimal setup time, supports high-speed links (commonly used for 10Gb and similar SFP+ interfaces), and is coded for compatibility with HP/HPE/Aruba devices. Technical support is available from ACT for product and compatibility questions.

Suitable for

Key specifications

How to use

Insert each SFP+ connector into the corresponding SFP+ port on your network devices until the latch engages. No additional configuration or transceivers are required for passive DAC operation. Ensure both devices support SFP+ passive DAC cables and power is applied according to your network maintenance procedures before testing the link.

Recommendations

Use this 2 m passive DAC Twinax cable for short, high-speed connections inside racks or between adjacent racks. Avoid stretching or sharply bending the cable near the connectors, and keep it clear of hot exhaust paths in densely packed equipment. Verify compatibility with HP/HPE/Aruba firmware and port settings if any link issues occur.