ACT Cable de parcheo U/UTP CAT6A naranja de 7 m con conectores macho RJ45, snagless

The ACT Orange 7 meter U/UTP CAT6A patch cable with RJ45 connectors is designed for reliable high-speed data transmission in structured network environments. This 7 m cable follows the CAT6A standard and uses unshielded twisted pair (U/UTP) wiring to support up to 10 Gbps Ethernet over copper where infrastructure and equipment permit. Snagless RJ45 boots and gold-plated contacts provide stable connections and reduce contact corrosion, while the bright orange jacket makes the cable easy to trace in racks and cable runs.

Advantages

The cable delivers consistent signal integrity suitable for modern Ethernet networks and is manufactured to meet CAT6A performance parameters for reduced crosstalk and improved high-frequency performance. Its snagless connector design protects the latch during installation and removal, and gold-plated contacts enhance conductivity and resistance to oxidation. The visible orange jacket simplifies identification and organization in multi-cable installations.

Suitable for

• 10/100/1000/10G Ethernet connections in offices and data closets
• Connecting switches, patch panels and network devices in server rooms
• Structured cabling where color-coded cable management is required
• Temporary or permanent runs requiring a 7 meter length

Key specifications

• Category: CAT6A (supports 10 Gigabit Ethernet where infrastructure permits)
• Topology: U/UTP (unshielded twisted pair)
• Length: 7 meters
• Connector type: RJ45 plug with snagless boot
• Contact plating: gold-plated contacts
• Jacket color: orange for easy identification

How to use

Route the cable between network devices avoiding tight bends and sharp edges to maintain cable performance. Insert RJ45 plugs firmly into device ports until the latch clicks, ensuring proper seating of the connectors. For best results, connect the cable end-to-end between patch panels, switches, routers or wall outlets designed for copper Ethernet, and avoid running the cable in parallel with high-voltage power lines to minimize interference. Test the link with appropriate network testing tools after installation to verify signal quality and connectivity.

Recommendations

For optimal long-term performance, avoid excessive bending radius (do not exceed the manufacturer’s recommended bend radius), keep cable length within standards for Ethernet segments, and use color-coded management in racks and patch panels to maintain clear identification. Use in environments matching U/UTP deployment (without additional shielding) and verify connector fit with the specific equipment ports before final routing.